3Wood Stove Insert with Stainless Liner

A wood stove insert installed in an existing masonry fireplace, vented through a stainless steel liner in the original flue.

WOOD STOVE INSERT WITH STAINLESS LINER Side cross-section of an insert installed in an existing masonry fireplace and chimney Chimney cap Liner top plate Crown Damper block-off platesealed at the damper area Surround panel Wood stove insert Hearth extension* Existing masonry chimney Stainless steel flue liner*sized to the appliance Liner connects to insert flue collar Existing masonry fireplace * Liner sizing and listing, liner insulation, hearth extension size, and clearances vary by appliance and code. Verify with NFPA 211 / IRC R1001–R1003 / Oregon Residential Specialty Code and the manufacturer's installation manual. Simplified educational illustration — not to scale and not an installation guide.
Tap or click the diagram to open it full size.

Parts glossary

Chimney cap
Cap over the liner that keeps out rain and debris; typically attached to the top plate.
Liner top plate
Plate that seals the top of the flue around the liner and supports it; the cap attaches to it.
Crown
Concrete or mortar slab on top of the chimney masonry that sheds water.
Existing masonry chimney
The original brick chimney that now houses the liner.
Stainless steel flue liner*
Listed stainless liner (flexible or rigid) running from the insert to the top of the chimney, sized to the appliance.
Damper block-off plate
Sheet-metal plate sealed at the damper area around the liner; keeps room air from escaping up the old flue and keeps cold air and debris out.
Liner connection to insert flue collar
Where the liner attaches to the insert’s outlet using the liner’s listed connector.
Surround panel
Metal panel around the insert that covers the gap between the insert and the fireplace opening.
Wood stove insert
Wood-burning heater designed to sit inside an existing fireplace firebox.
Existing masonry fireplace
The original firebox and masonry that now hold the insert.
Hearth extension*
Noncombustible floor area in front of the insert that protects the floor from embers.

Verify with code / manual *

Verify with NFPA 211 / IRC R1001–R1003 / Oregon Residential Specialty Code and the manufacturer’s installation manual and listing.