4Gas Insert in a Masonry Chimney

A direct-vent (sealed combustion) gas insert in an existing masonry fireplace, vented up the chimney flue with a co-linear liner system.

GAS INSERT IN A MASONRY CHIMNEY Side cross-section of a direct-vent gas insert installed in an existing masonry fireplace, vented up the chimney flue CO-LINEAR VENTING One liner carries exhaust up; a second liner brings outside combustion air down to the sealed insert. Some systems use a single co-axial liner instead.* Co-linear termination cap* Liner top plate Crown Exhaust liner*flexible aluminum Surround panel Glass front (sealed) Logs / media Pilot / ignition Burner Hearth extension* Gas supply line*up through the floor, one side Or: through a fireplace side wall near the bottom Existing masonry chimney Combustion-air intake liner*flexible aluminum Damper area*damper removed or locked open per manual Liner connections toinsert vent collars Direct-vent gas insert Gas shutoff valve Ash dump (at back wall) Existing masonry fireplace Exhaust (up the exhaust liner) Combustion air (down the intake liner) * Liner type, size and listing, termination cap, damper handling, gas line sizing, hearth extension, and clearances vary by manufacturer and code. Verify with NFPA 54 / IRC (fuel gas) / Oregon Residential Specialty Code and the manufacturer's installation manual. Simplified educational illustration — not to scale and not an installation guide.
Tap or click the diagram to open it full size.

Parts glossary

Co-linear termination cap*
Listed cap at the top of the chimney that terminates both liners: exhaust out, combustion air in.
Liner top plate
Plate that seals the top of the flue around the liners and supports them.
Crown
Concrete or mortar slab on top of the chimney masonry that sheds water.
Existing masonry chimney
The original brick chimney that now houses the vent liners.
Exhaust liner* (flexible aluminum)
Liner that carries combustion exhaust from the insert up and out of the chimney.
Combustion-air intake liner* (flexible aluminum)
Liner that brings outside air down to the sealed firebox for combustion. Some systems use a single co-axial liner (pipe within a pipe) instead of two liners.
Damper area*
Where the old damper was; removed or locked fully open as the insert manual requires so it cannot close on the liners.
Liner connections to insert vent collars
Where the exhaust and air-intake liners attach to the insert’s two vent collars.
Direct-vent gas insert
Sealed-combustion gas heater that takes all combustion air from outside and vents all exhaust outside.
Glass front (sealed)
Glass panel that seals the firebox from the room; it is part of the sealed combustion system.
Logs / media
Ceramic logs, glass, or stones; place them exactly as the manual shows, because placement affects the flame and sooting.
Pilot / ignition
Standing pilot or electronic ignition that lights the burner, with a flame-sensing safety device.
Burner
Where gas mixes with air and burns.
Gas shutoff valve
Manual valve that shuts off gas to the appliance; it must stay accessible.
Gas supply line*
Gas piping that typically comes up through the firebox floor in front of the ash dump (toward one side) or through a fireplace side wall near the bottom.
Surround panel
Panel around the insert that covers the gap to the fireplace opening.
Ash dump (at back wall)
Existing ash dump in the firebox floor near the back wall, left in place under the insert.
Existing masonry fireplace
The original firebox and masonry that now hold the insert.
Hearth extension*
Noncombustible floor area in front of the insert, as the insert’s listing requires.

Verify with code / manual *

Verify with NFPA 54 / IRC (fuel gas) / Oregon Residential Specialty Code and the manufacturer’s installation manual and listing.